Low Loss 400 FLEX Cable Assembly
|
||||||||
FACTORY DIRECT - WE ARE THE MANUFACTURER PRODUCED TO STRICT QUALITY CONTROL STANDARDS SATISFACTION GUARANTEE AND WARRANTY BUY FACTORY DIRECT FROM JEFA TECH FOR GUARANTEED QUALITY JEFA Tech Low Loss 400 Flex is a high performance alternative to Times Microwave SystemsŪ LMR-400UF and Belden 9913F7 flexible coax cable. Low Loss 400 Flex is recommended for applications where the coax cable will be in motion, for example, beam antennas that are on a rotator, or patch cables to go from your patch panel to radio equipment. The stranded center conductor and flexible jacket allow the cable to flex easily. Continuous flexing will not compromise the integrity of the cable. TECHNICAL SUMMARY:
Comparison of Popular .405" Size Coax Attenuation (Signal Loss) per 100/ft - (lower numbers are better)
Note that you are trading a small amount of performance to gain flexibility. For maximum performance in a permanent (non moving) installation, standard Low Loss 400 (LL400) with the solid center conductor is recommended. For installations that will have the cable in motion such as around a rotor, Low Loss 400 FLEX is recommended. Are you an amateur radio operator? This cable is the same size as RG-8 and RG-213 but with much better performance. Upgrade your shack to this higher quality, much lower loss cable today! It will dramatically reduce your signal loss on VHF and UHF. It will increase your receive signal and handle more power on HF. JEFA Tech coax is used by many fine ham radio operators world wide and is even used by the experimental HAARP (High Frequency Active Auroral Research Program) in Alaska. CB OPERATORS - Get the most bang for your buck by upgrading your coax cable to JEFA Tech LL400. Trusted by many CB operators for years. QUALITY AND PERFORMANCE: We stand behind the quality and performance of our cables. Our cables are guaranteed to be of the highest quality and performance or your money back. PRODUCTION DETAILS: This cable is professionally assembled and tested in our manufacturing facility in Maryland, USA! You are purchasing a completed cable assembly with connectors professionally attached to the cable. The ends are soldered and crimped, heat shrink is applied to seal the cable to the connector and provide additional support and the cable is then tested to ensure proper assembly and performance. We use an Agilent N9912A RF Analyzer for cable testing. SAME DAY SHIPPING: These cables are built-to-order. We have an optimized production line for these assemblies so most orders will ship the same day! RETURN POLICY: Since these cables are built-to-order, they are not returnable if you make a mistake when choosing the connector types or length. To see pictures of connectors, please see the connector identifier link at the top of the website. If you need assistance, please contact us. If you need a connector which is not listed, or if have a special need, please check our Custom Cable Request |
| Tweet |
|
